Detailed Error Codes - Fujitsu ETERNUS VSS Hardware Provider 2.1 User Manual

Table of Contents

Chapter 9 Messages

9.3 Detailed Error Codes

9.3

Detailed Error Codes

The detailed error codes output by the ETERNUS Disk storage systems are listed below.

Table 9.1 Detailed Error Codes

Invalid logical volume name

invalid source OLU.

invalid destination OLU.

invalid extent.

memory allocation error.

not STX.

SCSI command busy.

SCSI command conflict.

SCSI queue full.

hardware error requiring CE-CALL.

SCSI condition met.

unexpected SCSI error.

Detailed error code

ETERNUS VSS Hardware Provider 2.1 User's Guide

Take one of the following actions:

•

Check that the specified copy source or destination device

exists.

•

Check that the user privilege with which the operation is

performed is correct.

•

Check that the disk is initialized.

Check the partition information for the copy source device.

Check the partition information for the copy destination

device.

Check the slice information on the copy source or destination

device.

Allocate sufficient memory or a swap area, or terminate any

other programs that are being executed.

The disk is not ETERNUS Disk storage systems disk.

Take the applicable action as follows:

•

Ensure that the OPC/EC copy source is not used for

another copy target.

•

Ensure that the OPC/EC copy target is not used for

another copy source.

•

Ensure that the OPC/EC copy target is not used for

another copy target.

•

Wait for about five seconds and then re-execute

processing.

•

Confirm the status of the copy by using ETERNUS Web

GUI.

For other cases, contact a Fujitsu customer engineer.

SCSI error (Commandconflict) was detected.