Bios Update - Dell PowerEdge M620 Owner's Manual

Table 1-27. Blade Messages
Message
PCI BIOS failed to
install.
Plug & Play
Configuration
Error.
PCIe Training
Error: Expected
Link Width is x',
Actual Link Width
is x
ROM bad checksum =
address

BIOS Update

Attempt Failed.
Invalid
configuration
information -
please run SETUP
program
(continued)
Causes
Faulty or improperly
installed mezzanine card.
Error encountered in
initializing PCI device;
faulty blade board.
Faulty or improperly
installed PCIe card in the
specified slot.
Expansion card improperly
installed or faulty.
BIOS remote update
failed.
CMOS checksum failure.
Corrective Actions
Reseat the mezzanine card.
See "I/O Module Mezzanine
Cards" on page 217. If the
problem persists, see
"Getting Help" on page 361.
Set the NVRAM_CLR
jumper to "on" and reboot
"Blade
the blade. See
System Board Jumper
Settings
" on page 331 for
the jumper location.
Check for a BIOS update. If
the problem persists, see
"Getting Help" on page 361.
Reseat the PCIe card in the
specified slot number. See
"Troubleshooting Expansion
Cards" on page 321. If the
problem persists, see
"Getting Help" on page 361.
Ensure that the expansion
card is installed properly. See
"Troubleshooting Expansion
Cards" on page 321.
Retry the BIOS update. If
problem persists, see
"Getting Help" on page 361.
Run the System Setup
program and review the
current settings. See "Using
the System Setup Program
and UEFI Boot Manager" on
page 137.
About Your System
129