Sd Vflash Card (Poweredge M915, M910, M710, M710Hd, M610, And M610X Only) - Dell PowerEdge M620 Owner's Manual

SD vFlash Card (PowerEdge M915, M910, M710,
M710HD, M610, and M610x Only)
NOTE:
For PowerEdge M915, M910 and M710HD, the iDRAC6 vFLASH card can be
set to IDSDM function along with the SD card by setting the Redundancy option to
Mirror mode in the Integrated Devices screen of system setup. When the IDSDM
function is enabled, the vFlash functionality of the iDRAC6 vFlash card gets
disabled.
NOTE:
In IDSDM (PowerEdge M915, M910, and M710HD only), the SD card in the
lower card slot is the primary card (SD1) and the SD card in upper card slot is the
secondary card (SD2).
The SD vFlash card plugs into the iDRAC6 Enterprise card at the back corner
of the blade.
1 Remove the blade. See "Removing a Blade" on page 155.
2 Install the SD vFlash card in the upper card slot. See Figure 3-28.
3 Install the blade. See "Installing a Blade" on page 158.
Figure 3-28. Installing and Removing an SD vFlash Card (PowerEdge M915, M910,
M710, M710HD, M610, and M610x)
1
2
1 SD vFlash card in upper card slot 2 iDRAC6 Enterprise card
Installing Blade Components
225