Installing An I/O Module; Enclosure Bezel; Removing The Enclosure Bezel - Dell PowerEdge M620 Owner's Manual

Installing an I/O Module

NOTE:
The I/O module must be installed in the appropriate I/O bay. See "Guidelines
for Installing I/O Modules" on page 52.
1 Unpack the I/O module and prepare it for installation.
For instructions, see the documentation that accompanied the I/O
module.
2 Remove the I/O connector cover from the back of the module. See
Figure 4-6.
3 Install the I/O module in the M1000e enclosure:
Lift the handle release latch and open the I/O module handle.
a
Slide the module into the enclosure.
b
Close the handle until it snaps securely into place and the module is
c
fully seated.
4 Connect all cables that must be attached to the I/O module.
See the documentation provided with the I/O module for information
about its cable connections. For more information on using the cable
enumerators to organize and manage the cables, see the Rack Installation
Guide.
5 A matching fabric mezzanine card must be installed in one or more blades
to support the new I/O module. If necessary, install the mezzanine card(s)
now. See "I/O Module Mezzanine Cards" on page 217.

Enclosure Bezel

Removing the Enclosure Bezel

1 Press the system power switch to turn off the system. See "System Control
Panel Features" on page 16.
2 Rotate the LCD module so that the underside of the module faces
upward. See Figure 4-11.
3 Remove the cable cover and disconnect the ribbon cable from the LCD
module.
4 Remove the screws that secure the bezel to the enclosure. See Figure 4-7.
298
Installing Enclosure Components