Normal Operation; Bios Update - Dell DX6000G Hardware Owner's Manual

Table 1-2. System Messages
Message
BIOS
MANUFACTURING
MODE detected.
MANUFACTURING
MODE will be
cleared before
the next boot.
System reboot
required for
normal
operation.

BIOS Update

Attempt Failed!
Caution!
NVRAM_CLR jumper
is installed on
system board.
Please run SETUP
CPU set to
minimum
frequency.
CPU x installed
with no memory.
38
About Your System
(continued)
Causes
System is in manufacturing
mode.
Remote BIOS update
attempt failed.
NVRAM_CLR jumper is
installed in the clear setting.
CMOS has been cleared.
The processor speed may be
intentionally set lower for
power conservation.
Memory modules are
required but not installed in
the indicated processor's
memory slots.
Corrective Actions
Reboot to take the system
out of manufacturing mode.
Retry the BIOS update.
If problem persists,
see "Getting Help" on
page 169.
Move the NVRAM_CLR
jumper to the default
position (pins 3 and 5).
See Figure 6-1 for jumper
location. Restart the system
and re-enter the BIOS
settings. See "Using the
System Setup Program and
UEFI Boot Manager" on
page 55.
If not an intentional setting,
check any other system
messages for possible causes.
Install memory modules for
the processor. See "System
Memory" on page 110.