Chapter 2: Installing and Configuring UNIX Printing Software on a HP/UX System
Installing UNIX Printing Software on an HP/UX System
Instructions for installing UNIX Printing Software on an HP/UX System are as
follows:
1. Enter the following command at the command line. Press
2. Press
3. Enter the following new pathname for
4. Enter the following new flag for LPRFLAG:
i
2-308/25/02
./lpspr_install
#
The following prompt appears:
Select LPSROOT [/opt/lpspr]:
is an upper level directory structure under which the rest of the code
LPSROOT
will be installed.
to accept the default, or enter another pathname to be used by
RETURN
LPSROOT.
Another prompt appears:
Select LPRCOM [/usr/bin/lpr]:
/usr/bin/lp
Another prompt appears:
Select LPRFLAG [-P]
# LPRFLAG [-P]:-d
The following message appears:
Installation is successful.
If the installation is unsuccessful, you must deinstall the existing software,
before you can reinstall it. Refer to the section,
Software" on page 2-31
LPRCOM
for instructions on how to accomplish this task.
UNIX Printing Software Administration and Installation Guide
.
RETURN
. Press
.
RETURN
"Deinstalling UNIX Printing