Use Telnet To Remove An Ip Address - HP Jetdirect 640n Administrator's Manual

Figure 3-1
Main Menu
-------------------------------
1. General Menu
2. TCP/IP Menu...
3. SNMP Menu...
4. IPX/SPX Menu
5. AppleTalk Menu
6. DLC/LLC Menu
7. Other Settings
8. Support Settings
9. Wireless Settings
?. Help
e. Exit Menu
0. Exit Telnet
Enter Selection => 2
-------------------------------
1. TCP/IP - Main Settings
2. TCP/IP - Print Options
3. TCP/IP - Raw Print Ports
4. TCP/IP - Access Control
5. TCP/IP - Other Settings
6. TCP/IP - Diagnostics
0. Return to Main Menu
Enter Selection => 1
To edit these parameters, enter Y. Use the
Changes are not saved until you save them when you exit the session.

Use Telnet to remove an IP address

To erase the IP address during a Telnet session, use the following command line entries:
1. Type cold-reset, then press Enter.
2. Type quit, then press
3. Turn the print server off and then on.
60 Chapter 3 TCP/IP configuration
Example: Using the Menu Interface
TCP/IP Menu
TCP/IP - Main Settings
-------------------------------
Host Name
IP Config Method : USER SPECIFIED
IP Address
Subnet Mask
Default Gateway
Config Server
TFTP Server
TFTP File Name
Domain Name
DNS Server
Pri WINS Server
Sec WINS Server
SMTP Mail Server : Not Specified
Would you like to change any of the settings? (Y/[N]):Y
Enter to exit Telnet.
: printer1
: 192.168.45.39
: 255.255.0.0
: 192.168.40.1
: 192.168.2.21
: 192.168.2.21
: hpnp/print.cfg
: Not Specified
: Not Specified
: Not Specified
: Not Specified
Backspace key to edit the parameters.
ENWW