HP Jetdirect 640n Administrator's Manual page 68

Table 3-3 Telnet Commands and Parameters (continued)
1000t-ms-conf
1000t-pause-conf
network-select
link-type
hw-acclrn-conf
58 Chapter 3 TCP/IP configuration
Configure the print server as a master or slave device on a 1000T network.
AUTO or 0 (default): Master/slave configuration is automatically sensed and assigned.
MASTER or 1: Configure as a 1000T master device.
SLAVE or 2: Configure as a 1000T slave device.
Control the flow of inbound and outbound data.
OFF or 0 (default): Disable flow control.
AUTO or 1: Configure through auto-negotiation with the network switch.
RCV or 2: Enable only for data received from the network.
TRANS or 3: Enable only for data transmitted to the network.
TXRX or 4: Enable for both received and transmitted data.
(For HP Jetdirect products with a dual wired/wireless port. Specifies the active behavior
of the print server.)
●
Auto (default): Automatically detects whether a network cable is attached. If a
network cable is not attached, only the IEEE 802.11bgn wireless port is active. If a
network cable is attached, then only the IEEE 802.3 wired port is active.
CAUTION: Do not plug a network cable into an active wired/wireless port if the
network-select command is set to Auto. Wireless access will immediately
terminate.
●
Wired: Only the 802.3 wired port is active.
●
Wireless: Only the 802.11bgn wireless port is active.
(For wired 10/100/1000T Ethernet.) Set the print server's link speed (10, 100, 1000
Mbps) and communication mode (Full- or Half-Duplex). The available link-speed
depends on the print server model. Select from the following communication modes:
AUTO (default): Use auto-negotiation to configure the highest link speed and
communication mode allowed.
1000FULL: 1000 Mbps, full-duplex operation.
100AUTO: Limit auto-negotiation to a maximum link speed of 100 Mbps.
100FULL: 100 Mbps, full-duplex operation.
100HALF: 100 Mbps, half-duplex operation.
10FULL: 10 Mbps, Full-duplex operation.
10HALF: 10 Mbps, half-duplex operation.
Use hardware acceleration.
0: Disable.
1 (default): Enable.
ENWW