HP Jetdirect 640n Administrator's Manual page 62

Table 3-3 Telnet Commands and Parameters (continued)
bonjour-pri-svc
ftp-download
ttl-slp
ipv4-multicast
idle-timeout
user-timeout
52 Chapter 3 TCP/IP configuration
Highest priority Bonjour service to use for printing. Set this parameter using the following
values:
1: Port 9100 printing
2: IPP port printing
3: Default LPD raw queue
4: Default LPD text queue
5: Default LPD auto queue
6: Default LPD binps (binary PostScript) queue
7 through 12: If user-specified LPD queues are defined, corresponds to user-specified
LPD queues 5 through 10.
Although the default selection depends on the printer, it is typically Port 9100 printing or
LPD binps.
Download firmware upgrade files to the print server, using FTP.
0: Disable.
1 (default): Enable.
IP multicast time-to-live (TTL) setting for SLP packets. The default value is 4 hops (the
number of routers from the local network). Set from 1 to 15 hops.
-1: Disable.
4 (default): Enable multicast TTL.
Receive and transmit IP version 4 multicast packets by the print server.
0: Disable.
1 (default): Enable.
NOTE: If disabled, other protocols that use multicast protocols, such as Bonjour and
SLP, might also be disabled without notification.
Seconds that an idle print data connection can remain open. Set from 1 to 3600
seconds.
0: Disable. Connection does not terminate. Other hosts cannot make a connection.
270 (default): Enable.
Seconds that a Telnet or FTP session is idle before it is automatically disconnected. Set
from 1 to 3600 seconds.
0: Disable.
900 (default): Enable.
CAUTION: Setting this to a short time period might disable Telnet/FTP, because a
session could terminate before changes can be made.
ENWW