HP Jetdirect 640n Administrator's Manual page 54

Table 3-3 Telnet Commands and Parameters (continued)
AMPDU Aggregation
network-type
desired-ssid
auth-type
server-auth
svr-auth-user
svr-auth-pass
svr-auth-id
wpa-auth-type
44 Chapter 3 TCP/IP configuration
Aggregating 802.11n MAC protocol data units packs them into frames to reduce
overhead and increase the data rate. Enabling aggregation allows a maximum frame
size of 64k bytes.
ENABLE (default):Enable aggregation.
DISABLE: Disable aggregation.
802.11bgn wireless network topology:
Infrastructure: The print server communicates on the network with other wired or
wireless devices through an access point.
Ad Hoc: (default) The print server communicates with other wireless devices directly,
without using an access point.
Service set identifier (SSID), or network name, for the print server. Enter up to 32
alphanumeric characters.
The factory-default SSID is hpsetup in ad hoc mode. Do not use the SSID hpsetup
with the Infrastructure network type.
If the ssid command is issued without an entry (a blank SSID), the desired SSID is
assigned <AUTO>, where it associates with the first network that matches its
authentication settings.
Link-based authentication method for the print server (before network use is allowed).
Open (default): Use open system authentication if your wireless network does not
require authentication for network use. However, your network might use WEP
encryption keys for data security.
Shared_Key: Use shared key authentication if your network requires that each device
be configured with the same secret WEP key for network use.
Selecting Shared_Key is not valid with the wpa-auth-type command when setting
WPA-PSK authentication.
Use server-based authentication.
EAP_TLS: Use EAP-TLS authentication.
NONE (default): Do not use server-based authentication.
PEAP: Use PEAP authentication.
802.1x server authentication user identity. Enter up to 128 characters.
Server authentication password. Enter up to 128 characters.
Server authentication ID, using the form: [<server(host name string)] The default value is
RIGHT_MOST.
WPA-PSK authentication and dynamic wi-fi protected access (WPA) encryption. WPA-
PSK provides enhanced authentication on networks where an authentication server is
not used. (Not compatible with the shared key authentication option in the auth-type
command.)
NONE: WPA-PSK authentication is not used.
PSK: Selects WPA-PSK authentication. A pre-shared key provides device authentication
and is generated when you specify a network passphrase through the psk-
passphrase command.
ENWW