Chapter 3: Device Bay; Assumptions - EUROCOM 3400 UltraLite User Manual

3 Device Bay
This chapter is about setting up and using modules in the device bay:
CD-ROM
FDD
S N
OFTWARE OTES
Like the last chapter, we only
cover essential setup instructions
in Windows 9x, 2000, and NT4
operating systems. For other op-
erating systems, check the
"readme.txt" file on the "root
level" of the Device Drivers & Tools
CD-ROM, or consult your dealer.
DVD-ROM CD-RW
LS-120
A
SSUMPTIONS
In our explanations, we assume
your system was installed with a
CD device in the device bay and is
"drive D:". If the drivers are located
somewhere else, just substitute
that source in the configuration.
For driver installations, we also as-
sume your system is setup to view
all files and file extensions.
Setup Note
If you're setting up your system for
the first time, you should have al-
ready installed these critical driv-
ers in the correct sequence –
USB and Intel 82371 (page 2-18)
Direct X7.0 or later (page 2-10)
Video (page 2-10)
Audio (page 2-12)
Networking Note
Make sure you've downloaded
the driver from the network
source to your hard drive before
you begin any installation. In
some cases, the operating sys-
tem must reboot as part of the
installation process and recon-
necting to the network may not be
practical.
1
3
4
5
6
7
8
3 – 1