EUROCOM 3400 UltraLite User Manual page 49

PC Card Setup
Windows 95
The PC Card socket uses technolo-
gies which are newer than Windows
95 . Before installing these newer
drivers for Windows 95 , you should
install the USB & related Chipset driv-
ers (refer to page 2-18 later in this
chapter).
To upgrade the PC Card driver:
1. Insert the Device Drivers & Tools
CD-ROM.
2. Go to the Start menu,
click on Run...>Browse...
3. Navigate to:
d:\drivers\win95\
pcmcia\setup.exe
4. Click on Open, Yes or OK as you
follow the instructions.
Note: During the installation, you may be
asked to instert the Windows 95 disk.
5. When the installation finishes, al-
low the system to restart.
Windows NT 4.0
The operating system automatically
installs the PC Card socket drivers.
However, it is only PCMCIA (rev. 2)
compliant, so you can install or re-
move cards only when the system is
turned off. In particular, any I/O PC
Card (e.g. SCSI) must be present when
you boot-up the system. ZV support
is not available.
System: pc cards
2 – 15
1
2
3
4
5
6
7
8