EUROCOM 3400 UltraLite User Manual page 126

Troubleshooting:
1
2
3
4
5
A
B
B
B – 12
operation
T S -
HE AVE TO
possible cause:
indicator:
solution:
T
HE SYSTEM NEVER GOES INTO
possible cause:
solution:
T
HE SYSTEM DOES NOT GO INTO
possible cause:
solution:
-D
ISK FUNCTION DOES NOT WORK
The system can't access the Save to Disk partition.
When you press the
Suspend is activated instead of Save to Disk.
(1) Make sure you have enabled Save to Disk in the
Power menu in Setup . Refer to Chapter 4: Firmware .
(2) Set up the Save to Disk partition if you haven't done
so. Refer to Chapter 5: Power .
(3) Run the PHDISK utility if you installed a different hard
disk with a Save to Disk partition on it, or there has
been a CMOS or Checksum failure.
S
USPEND MODE
Power management features are not enabled.
Go to Setup 's Power menu and enable the features
you prefer. Refer to the Power Management section of
Chapter 5: Power .
S
USPEND OR
Suspend Timeout is disabled.
Use one of the Power Management presets or manu-
ally set the Suspend Timeout in the Power menu in
Setup . See Chapter 4: Firmware and Chapter 5: Power .
.
Fn + key combination, normal
.
S D
AVE TO ISK WHEN THE BATTERY IS LOW
.