EUROCOM 3400 UltraLite User Manual page 128

Troubleshooting:
1
2
3
4
5
Faster Repairs
Keep a record of any warning
messages; it may help to reduce
A
repair time.
B
B
B – 14
warnings
W
ARNING
Each time you boot up, the computer performs a self-diagnostic check.
If there is an error during the self-diagnosis, a short message will dis-
play specifying the error. You can press F1 to try to continue the boot
process, or press F2 to run Setup.
If the following messages occur, press F2 to run Setup.
message:
description:
solution:
message:
description:
solution:
M
ESSAGES
Extended RAM failed at offset: nnn
The extended memory is not working or not config-
ured properly.
1. Make sure the expansion memory is seated prop-
erly in its socket(s) (refer to Chapter 6: Extras ).
2. Run Setup to allow the system to recheck the amount
of memory present, then save the Setup information
and reboot (refer to Chapter 4: Firmware ).
Failing Bits: nnnn
The hex number, nnnn, is a map of the bits at the RAM
address that failed the memory test.
1. Make sure the expansion memory is seated prop-
erly in its socket(s) (refer to Chapter 6: Extras ).
2. Run Setup to allow the system to recheck the amount
of memory present, then save the Setup information
and reboot (refer to Chapter 4: Firmware ). 3. Turn off
the system and remove any DIMMs (refer to Chapter