Table of Contents
Advertisement
6: Extras ). Restart the system. If the problem persists,
contact your service center. If the problem disappears,
replace the DIMMs one at a time to identify the defec-
tive module. Replace any defective DIMMs.
message:
Fixed Disk x Failure or Fixed Disk Controller Failure
description:
The hard disk is not working or is not properly config-
ured.
solution:
1. Check that the HDD is properly attached (refer to
Chapter 6: Extras ).
2. Run Setup to make sure the HDD is correctly config-
ured (refer to Chapter 4: Firmware ).
3. Make sure the HDD's jumper settings are correct -
"master" (refer to Chapter 6: Extras ).
message:
Incorrect Drive A: type - run Setup
description:
The FDD is incorrectly identified in Setup .
Run Setup and check that the FDD is correctly mounted
solution:
or attached (refer to Chapter 4: Firmware ).
message:
Keyboard controller error
description:
The keyboard controller failed the POST.
solution:
1. Try restarting the system.
2. If you are using an external keyboard, remove it and
make sure the onboard keyboard works correctly. If it
does, you may have to replace the external keyboard.
3. If the problem persists, contact your service center.
Troubleshooting:
warnings
B – 15
1
2
3
4
5
A
B
B
Advertisement
Table of Contents
Need help?
Do you have a question about the 3400 UltraLite and is the answer not in the manual?
Questions and answers