Removing The Cr Assembly - Epson Stylus COLOR 880 Service Manual

EPSON Stylus COLOR 880

4.2.4.7 Removing the CR Assembly

1) Remove the Upper Housing. (Refer to Section 4.2.1)
2) Remove the Tension Spring 1.494 fixing the CR Encoder Slit Plate to the
protrusion in the left side of the Top Frame and remove the CR Encoder
Slit Plate carefully from the CR unit.
Figure 4-41. Remove the Tension Spring 1.491& CR Encoder Slit
3) Loosen the Timing Belt by pushing the Driven Pulley Holder to Right and
remove the Timing Belt from the pinion gear of the CR motor. Refer to
Figure 4-40.
4) Using tweezers, take the Compression Spring 23.52 out of the Driven
Pulley Holder. Refer toFigure 4-42.
Disassembly and Assembly
Tension Spring 1.494
CR Encoder Slit Plate
Disassembly Procedures
Compression Spring 23.52
Figure 4-42. Taking Out the Compression Spring 23.52
5) Slide the Driven Pulley Holder to the right and remove it to the front.
6) Remove the Driven Pulley from the Driven Pulley Holder together with the
timing belt. Refer to Figure 4-43.
Driven Pulley Holder
Figure 4-43. Removing the Driven Pulley
Revision A
Driven Pulley Holder
Driven Pulley
105