Overview; Precautions For Disassembling The Printer - Epson Stylus COLOR 880 Service Manual

EPSON Stylus COLOR 880

4.1 Overview

This chapter describes procedures for disassembling the main components of
EPSON Stylus COLOR 880. Unless otherwise specified, disassembly units or
components can be reassembled by reversing the disassembly procedure.
Therefore, no assembly procedures are included in this chapter. Precautions
for any disassembly or assembly procedure are described under the heading
"CHECK POINT". Any adjustments required after disassembling the units are
described under the heading "ADJUSTMENT REQUIRED".
Disassembly and Assembly

4.1.1 Precautions for Disassembling the Printer

See the precautions given under the heading "WARNING" and "CAUTION" in
the right column and the following page, respectively, when disassembling or
assembling EPSON Stylus Color 440/640/740.
Disconnect the power cable before disassembling or
assembling the printer.
Wear protective goggles to protect your eyes from ink. If ink
gets in your eye, flush the eye with fresh water and see a
doctor immediately.
Wear a pair of gloves to protect your hands than the sharp
edge in the printer mechanism.
If ink comes into contact with your skin, wash it off with
soap and water. If irritation occurs, contact a physician.
A lithium battery is installed on the main board of this
printer. Be sure to observe the following instructions when
serving the battery:
Keep the battery away from any metal or other batteries so
that electrodes of the opposite polarity do not come in
contact with each other.
Do not heat the battery or put it near fire.
Do not solder on any part of the battery. (Doing so may
result in leakage of electrolyte from the battery, burning or
explosion. The leakage may affect other devices close to
the battery.)
Do not charge the battery. (An explosion may be generated
inside the battery, and cause burning or explosion.)
Do not dismantle the battery. (The gas inside the battery
may hurt your throat. Leakage, burning or explosion may
also be resulted.)
Do not install the battery in the wrong direction. (This may
cause burning or explosion.)
Danger of explosion if the battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacture. Dispose the used
batteries according to government's law and regulations.
Overview
Revision A
77