Epson Stylus COLOR 880 Service Manual page 100

EPSON Stylus COLOR 880
When installing the ASF assembly, make sure that the
protrusion on the ASF is assembled into the fixing hole in
the Middle Frame.
Engage the Gear 32 (ASF Unit) and Combination Gear 14,28
(DE unit) carefully when installing the ASF unit is to the
Bottom Frame. Otherwise, gears may be damaged. Refer to
Figure 4-31.
Middle Frame
Combination Gear
14, 28
Fixing Hole
Figure 4-31. Assembling notice for ASF Assembly.
Disassembly and Assembly
Gear 32
Protrusion on
the ASF
Disassembly Procedures
Screws for ASF Assembly should be used at the following
positions. (Looking from the back of printer). Refer to
Figure 4-29.
- Right Side (viewed from the front): ASF Fixing Screw
- Left side (viewed from the front): Screw No.7
Make sure the ASF HP sensor cable and the PF Motor
Cable are set in the hook on the right side (viewed from
the back) of ASF unit. Refer to Figure 4-32.
Setting the ASF HP Sensor and
PF Motor Cable to the hook.
Figure 4-32. Setting the ASF HP Sensor & PF Motor cable
Revision A
100