Table of Contents
Advertisement
before the first waveform, "LpS (Loop Start)" is set
immediately before the second waveform, and "E
(End)" is set as desired.
S (Start)
By using the ZOOM ([F4] key–[F7] key) you can
change the range that is displayed. When "S
(Start)" is highlighted, zoom will be performed
from the start address ( PG p.85).
If the "Zero (Use Zero)" check box is checked, only
those addresses where the waveform data crosses
the zero level will be found automatically when
searching, and can be set. This lets you easily make
address settings where noise is less likely to occur
when looping.
5 If necessary, use the Utility "Truncate" to delete
unwanted data that falls outside the start (or loop
start) and end addresses.
Set the parameters, and press the [F8] ("OK") key
to execute the operation. ( PG p.93)
For cautions on the "Save to No." and "Overwrite"
check boxes, refer to "A note on saving samples"
( p.73).
The grid display
The Utility "Grid" overlays the waveform display with
a grid based on the BPM tempo value. This makes it
easy to make loop settings that are synchronized to the
tempo.
In the same way, the grid display can also be used
in 2.1: Sample Edit, Edit2 page. The grid can help
you to edit the waveform in synchronization with
the tempo.
1 Select the "Grid" Utility.
The following dialog box will appear.
72
LpS (Loop Start)
E (End)
Check "Grid," set "Resolution" as desired, and
press the [F8] ("OK") key. The dotted grid lines will
appear.
2 Set " (Grid Tempo)" to the desired BPM tempo
value.
3 Set the end address so that it coincides with a dot-
ted line of the grid.
This will cause the loop interval to be the same
length as the BPM value.
The grid display will be based at "LpS (Loop Start)"
if looping is on. If looping is off, the grid will be
based at "S (Start)."
4 To hide the grid display, select the "Grid" utility,
uncheck "Grid," and press the [F8] ("OK") key.
The grid is displayed according to the playback
pitch of the base key (the key shown in gray in the
"Keyboard & Index" area).
You can select the base key by holding down the
[ENTER] key and playing a note on the keyboard
of a connected MIDI instrument.
Advertisement
Table of Contents
