Table of Contents
Advertisement
*
Dialog boxes
When you select a utility menu command etc., a
dialog box will open.
Use the cursor keys [
parameters. Use the VALUE controllers ( p.35) to
input the parameter values. When selecting pro-
gram or combination numbers in a dialog box, you
can use the [BANK] and [A]–[H] keys in addition
to the VALUE controllers.
As in the utility menu, press the function key [F1]–
[F8] nearest
etc. (function button 2) to access
the execution or operation screen. In some cases, a
dialog box will appear. Follow the directions
shown in the dialog box.
To execute, select
cancel without executing, select
[F7] key). The dialog box will close. The [EXIT] key
is equivalent to "Cancel," "Done," or "Exit."
*
Function buttons 2
Press the function key [F1]–[F8] nearest this button
to execute the function.
:
Utility menu, etc.
*
Text dialog box
When you use the function keys to select
text dialog box will appear.
In this dialog box you can rename text (e.g., the
name of a program, combination, or multi).
( p.38)
*
Scroll bar
This indicates that the list contains selections or
parameters that cannot all be shown in the screen
at once. Use the cursor keys [
move within the list.
10
], [
], [
], [
] to select
(press the [F8] key). To
(press the
, a
], [
], [
], [
] to
Scroll
bar
*
Page menu
In Combination, Program, Multi, Sampling, or
Global modes, pressing the [MENU] key will dis-
play a list of the pages in that mode. (The page in
which you where when you pressed the [MENU]
key will be highlighted.)
To select a page, press the nearest function key
[F1]–[F7]. By pressing the same key you can move
consecutively downward. You can also use cursor
keys [
], [
], [
], [
right.
You can also move to the desired page by holding
down the [MENU] key and using numeric keys
[0]–[9] to enter a two-digit page number. In addi-
tion, you can hold down the [MENU] key and use
the cursor keys [
] [
page; in the example shown below, this would be
Play
P/M
Ctrl
installed)
Prm1
*
Other objects
To use slider- or knob-shaped objects, or chain
parameter values, use the cursor keys [
[
], [
] to select the desired item, and use the
VALUE controllers to adjust the value.
Other types of objects are shown in the effect rout-
ing screen. ( p.96)
Sliders
Knobs
Routing
] to move left/up/down/
] to move in steps of one
MOSS (if the EXB-MOSS is
... etc.
], [
Chain
],
Advertisement
Table of Contents
