Table of Contents
Advertisement
12
F3
F4
OK
13
F3
F4
OK
14
F3
F4
OK
10
10-20
Changing the Fax Default Settings
If you want to set the transmission mode, press [F3] (▼) or
[F4] (▲) to highlight <05 TX MODE> ➞ press [OK].
The TX MODE menu appears.
Press [F3] (▼) or [F4] (▲) to select either <01 MEMORY
SENDING> or <02 DIRECT SENDING> ➞ press [OK].
<01 MEMORY SENDING>: Scans all pages into memory, and then sends them.
<02 DIRECT SENDING>: Starts scanning the document and sends the
document one page at a time without storing the document into memory.
The display returns to the FAX DEFAULT menu.
If you want your documents stamped after every
transmission, press [F3] (▼) or [F4] (▲) to highlight <06 TX
STAMP> ➞ press [OK].
The TX STAMP menu appears.
Advertisement
Table of Contents
