Canceling Send Jobs
This section describes the procedure to cancel a transmission in progress.
Canceling Transmission
Follow the procedure below to cancel sending documents during a transmission.
You can also cancel a transmission that has been preset to transmit at a specified
time by deleting the document if you know its transaction number.
1
During transmission, press [Stop].
Stop
If you are using Direct Sending, an alarm sounds, and the transmission is
canceled immediately.
If you are using Memory Sending, the message <CANCEL DURING TX/RX?> is
displayed.
If you press
feeder or during Direct Sending, the message <STOP KEY PRESSED PRESS
OK KEY> is displayed.
2
F3
Press [F3] (YES).
If the machine is scanning the document, or sending the document using Direct
Sending, press
After you press
report automatically prints, unless this feature has been turned 'OFF.' (See
"Setting Reports to Print Automatically," on p. 12-2.)
Scanning or sending stops.
NOTE
•
Sending is not canceled until you press
•
If you cancel during Direct Sending, you may have to open the feeder cover to
remove your document.
(Stop) while the machine is scanning a document placed in the
F4
(OK).
F3
(YES) to cancel the transmission, an alarm sounds, and a
F3
(YES).
Canceling Send Jobs
3
3-35