Table of Contents
Advertisement
Signal
Overload
Link
ration.
Note:
On/Power
Note:
WebZine Article
An interesting article about the SPL Transient Designer is available in the "Ask
The Doctors" section of our November 2007 WebZine:
• http://www.uaudio.com/webzine/2007/november/index2.html
UAD Powered Plug-Ins Manual
This 4-stage "LED" indicates the presence of audio signals at the
input of the plug-in. When the input signal is below –25 dB, the
indicator is off. At –25 dB to –19 dB, the indicator glows slightly.
At –18 dB to –10 dB, it lights with medium intensity. At –9 dB to
0 dB, it shines brightly.
The Overload "LED" illuminates when the signal level at the out-
put of the plug-in reaches 0 dBFS. The indicator matches the be-
havior of the original hardware unit. However, in the software
plug-in version, the output can be "overloaded" without causing
distortion.
Link indicates when stereo operation is active. It illuminates when
used in a stereo-in/stereo-out or mono-in/stereo out configuration.
It does not illuminate when used in a mono-in/mono-out configu-
Link is an indicator only; it does not control any plug-in parameter.
The On and Power switches determine whether the plug-in is ac-
tive. Click the On or Power switches to change the state. On and
Power illuminate when the plug-in is active.
When the plug-in is inactive, processing is disabled and UAD DSP
usage is reduced (unless
enabled).
The On and Power switches perform the exact same function.
"UAD-2 DSP LoadLock" on page 74
- 514 -
Chapter 52: SPL Transient Designer
is
Advertisement
Table of Contents
