Table of Contents
Advertisement
Table 3. Keyboard shortcuts
Keyboard Action:
Control + Click Parameter (Mac only)
Shift + Drag
UpArrow
RightArrow
Shift + PageUp
DownArrow
LeftArrow
Shift + PageDown
Shift + UpArrow
Shift + RightArrow
PageUp
Shift + DownArrow
Shift + LeftArrow
PageDown
Control + Click parameter (Windows)
Modifier* + Click parameter (Mac)
(*Modifier key set in Configuration Window)
Control + Shift + Click parameter (Windows)
Modifier* + Shift + Click parameter (Mac)
(*Modifier key set in Configuration Window)
DSP Loading Information
The UAD devices feature either one (UAD-1 & UAD-2 Solo), two (UAD-2 Duo),
or four (UAD-2 Quad) on-board DSP chips for processing Powered Plug-Ins.
In UAD-1-only systems, when there is more than one UAD-1 in the system, the
UAD-1 device that has the lowest resource usage will receive the next Pow-
ered Plug-In load. Note that an individual UAD-1 plug-in cannot be split
across two (or more) UAD-1 processors.
For example, let's say you have a two UAD-1 devices installed, the UAD
Meter displays 90%, you load another UAD plug-in that requires 6% DSP, yet
you get a "plug-in unable to load" message. This would occur if both devices
are already at 95% (the meter shows the total available DSP, not the per-de-
vice DSP), so a 6% plug-in can't load.
Multi-DSP UAD-2 systems use significantly enhanced load balancing routines.
UAD-2 plug-ins are always allocated as efficiently as possible, which is not
necessarily on the DSP with the lowest resource usage.
UAD Powered Plug-Ins Manual
Result:
Select parameter for keyboard control
(without changing its value)
Fine Control
Increment Fine
Decrement Fine
Increment Coarse
Decrement Coarse
Toggle initial editor setting (the value when the
editor window was last opened)
Revert to initial editor setting (the value when the
editor window was last opened)
- 93 -
Chapter 7: Using UAD Powered Plug-Ins
Advertisement
Table of Contents
