Table of Contents
Advertisement
Connecting
Important:
UAD-2 Satellite
"UAD Software Installation" on page
before or after the system is booted.
To connect UAD-2 Satellite:
1.
2.
3.
4.
5.
6.
7.
8.
UAD-2 Satellite connections are complete.
You are now ready to use UAD-2 Satellite. See
on page
ter.
Disconnecting
Important:
UAD-2 Satellite
UAD-2 Satellite from the computer to avoid unpredictable behavior and/or
data loss.
To disconnect UAD-2 Satellite:
1.
2.
Note:
powered, as long as the steps above are followed.
UAD Powered Plug-Ins Manual
Install the UAD software before connecting UAD-2 Satellite (see
Ensure that UAD v5.8.1 (or higher) software is already installed and that
the system was restarted after software installation. See
stallation" on page 28
Ensure that all UAD plug-in host software is quit.
Select a suitable location for the UAD-2 Satellite chassis (see
stall Location" on page
Connect the AC end of the
need a different AC connector for your country, see
Connect external power supply output cable to the DC input on the rear
panel of the UAD-2 Satellite chassis.
Connect one end of the FireWire cable to the FireWire port on the host
computer.
Connect the other end of the FireWire cable to the UAD-2 Satellite chassis.
Turn on UAD-2 Satellite using the power switch on the rear panel. The unit
may be powered on before connecting without consequence.
133. Additional connection methods are detailed later in this chap-
The proper sequence must be followed before disconnecting
Save your sessions and quit all UAD host software (audio applications and
the UAD Meter & Control Panel).
Disconnect UAD-2 Satellite from the FireWire port. Done!
UAD-2 Satellite may be disconnected when it and/or the computer is
28). UAD-2 Satellite may be connected
for specific instructions.
130).
External Power Supply
- 132 -
"UAD Software In-
"Satellite In-
to an AC outlet. If you
page
131.
"UAD-2 Satellite Operation"
Chapter 11: UAD-2 Satellite
Advertisement
Table of Contents
