Table of Contents
Advertisement
Repro
Repro mode models the sound of tape recording through the record head and
playback through the reproduction head, plus all corresponding machine
electronics.
Input
Input mode emulates the sound of the Ampex ATR-102 through the machine
electronics only, without tape sonics. This is the scenario when the machine is
in live monitoring mode but the tape transport is not running.
Thru
Thru is a processor bypass control. When Thru is enabled, all controls are in-
active, emulation processing is disabled, and DSP usage is reduced.
Thru behavior is similar to that of the OFF position in the POWER control
(page
the Meters indicate signal levels at the input of the plug-in prior to processing.
Note:
If DSP LoadLock is enabled (the default setting), activating Thru will not reduce
DSP usage.
Tape Reels
When the secondary controls panel is closed
Animation
(Figure 44 on page
graphical tape reels "spin" if the DAW trans-
port is running. The tape reels animation can
be disabled by clicking the capstan graphic.
Re-clicking the capstan will re-start the animation.
The "spin state" is saved until it is changed again.
Note:
Audition, Vegas). In Sonar, the plug-in must be configured as a "tempo-based
effect" for reels animation.
UAD Powered Plug-Ins Manual
154), except that the
DSP usage is reduced only when DSP LoadLock
147), by default the
Spinning reels automation is not supported in all hosts (e.g., Wavelab,
Meters
are still active in Thru mode. In this state,
- 158 -
(page
74) is disabled.
Click capstan
to start/stop
reels animation
Chapter 12: Ampex ATR-102
Advertisement
Table of Contents
