Table of Contents
Advertisement
UAD-2 Satellite Operation
After UAD Powered Plug-Ins software v5.8.1 (or higher) is installed
and UAD-2 Satellite is properly connected to the computer via FireWire
(page
for software operating instructions.
All UAD-2 Satellite operations (except for hardware setup) are similar to the
operation of other UAD-1/UAD-1e/UAD-2 devices. See
Satellite Notes" on page 135
For general information about FireWire and how it is used with UAD-2 Satel-
About FireWire
lite and other FireWire devices, see
"FireWire Bandwidth" on page
It is important to note that available FireWire bandwidth is unrelated to UAD
DSP loads. See
When power is applied to UAD-2 Satellite via the rear switch, the UA logo on
Power Indicator
the front panel glows. This power indicator does not represent the state of the
UAD drivers or their link to UAD-2 Satellite (the
operational state).
Figure 30. UAD-2 Satellite Power Indicator
UAD-2 Satellite has a UAD link indicator on the rear panel. This LED provides
Rear Panel LED
information about the operational state of the device and its drivers. For more
details, see
Figure 31. UAD-2 LED on Satellite rear panel
UAD-2 Satellite
After initial setup and before first use, UAD-2 Satellite should be registered
Authorization
and authorized (it can run in demo mode for 14 days without authorization).
See
UAD Powered Plug-Ins Manual
130), the system is ready for use. Refer to other chapters in this manual
"FireWire Bandwidth vs. UAD DSP" on page 143
"UAD-2 LED" on page
"Authorization" on page 32
for exceptions specific to UAD-2 Satellite.
"FireWire Basics" on page 137
141.
Rear Panel LED
36.
for full explanation and procedures.
- 133 -
(page
28)
"Important UAD-2
and
for details.
indicates the
Chapter 11: UAD-2 Satellite
Advertisement
Table of Contents
