Table of Contents
Advertisement
Cut Frequency
This knob determines the cutoff frequency for the Cut filters. The available
Knob
range is from 20 Hz – 5 kHz for the low cut filter, and 20 Hz – 20 kHz for
the high cut filter.
EQ Bands
All five of the EQ bands can be used in parametric or shelf mode. Each band
has identical controls, the only difference is the frequency range values.
The function of the controls is similar in both parametric and shelf modes. The
two modes are described separately (see
"Shelf EQ" on page
Figure 52. The EQ Band controls
Enable Button
Each band can be individually engaged with the Enable button. The button is
green when the band is enabled. All bands default to disabled. To enable
any band, click the Enable button.
You can use these buttons to compare the band settings to that of the original
signal, or to bypass the individual band. UAD DSP usage is slightly de-
creased when a band is disabled (unless
is enabled).
Frequency Knob
This parameter determines the center frequency to be boosted or attenuated
by the Gain setting. The available range for each of the five bands is the same
for both parametric and shelf modes. The ranges are shown in
page
UAD Powered Plug-Ins Manual
182).
179.
"Parametric EQ" on page 179
"UAD-2 DSP LoadLock" on page 74
- 178 -
and
Table 14 on
Chapter 13: Cambridge EQ
Advertisement
Table of Contents
