Table of Contents
Advertisement
• When UAD–Xpander power is on but there is no electrical connection to the
• When power is on and there is an electrical connection to the computer, the
Figure 25. UAD–Xpander Power Indicator
Note:
only. It does not indicate when UAD driver communication is established (use
the UAD Meter to check driver communication status).
Hot swapping is not supported. Hot swapping refers to the ability to discon-
"Hot" Swapping
nect the UAD ExpressCard while the notebook computer is active or sleeping,
and reconnect it at a later time without rebooting.
Note:
Xpander connected every time the UAD ExpressCard has been removed.
Disconnect
The UAD-Xpander can be disconnected when the notebook computer is active
or sleeping only if these two conditions are met:
1.
2.
To disconnect the UAD-Xpander while the notebook is active:
1.
UAD Powered Plug-Ins Manual
computer (such as when the computer is off), the UA logo glows red.
UA logo glows blue
The Power Indicator displays the state of the electrical connections
For proper functionality, you must reboot the computer with the
1. No host applications (including UAD Meter &Control Panel) are running.
2. The ExpressCard is properly powered down by the operating system.
Quit all UAD host applications, including the UAD Performance Meter.
This ensures that all UAD Powered Plug-Ins are inactive.
(Figure
25).
- 125 -
Chapter 10: UAD ExpressCard Products
Advertisement
Table of Contents
