Table of Contents
Advertisement
Cabinet On/Off
Enables or disables the Cabinet module within Preflex. The Cabinet is en-
Button
gaged when the button indicator is bright red. You can use this switch to com-
pare the Cabinet settings to that of the original signal or bypass the entire
Cabinet section to reduce UAD DSP load.
This LED-style VU meter displays the level of the signal at the output of the Cab-
Output Level
Meter
inet. Just before the red 'LED' is illuminated, the signal is at 0 dB. In order to
avoid overloading your host application signal path, adjust the Preflex output
level so that the signal is at or below 0 dB.
Phasor Module
The Phasor is a frequency-variable comb-filter with low frequency oscillator
modulation. It is capable of producing dramatic sweeping and swooshing ef-
fects, including modern and classic sounds such as those produced by the
Mutron Bi-Phase, Small Stone and MXR series of phasors.
Figure 133. The Phasor plug-in window
Sync Button
This button puts the plug-in into Tempo Sync mode. See
Sync"
Rate Knob
Sets the LFO modulation (sweep) rate of the Phasor. The available range is
from 0.03 Hz to 10 Hz.
The Sweep knobs determine the frequency range that will be affected by the
Sweep Knobs
Phasor. The low and high frequency values can be independently adjusted.
This flexible arrangement allows the Phasor to affect a narrow or broad fre-
quency range, and also enables you to tune the frequency response charac-
teristic to match the signal if desired.
UAD Powered Plug-Ins Manual
for more information.
- 404 -
Chapter 8, "Tempo
Chapter 38: Nigel
Advertisement
Table of Contents
