Table of Contents
Advertisement
Wow usually refers to very low frequency fluctuations, while Flutter refers to
faster fluctuations. Wow and flutter is measured as the percentage of deflec-
tion from the original pitch. Both are more pronounced at lower tape speeds.
Note:
fected by automatic calibration.
Determines the amount of Wow in the signal. Wow & Flutter Enable
Wow
must be ON for this control to function.
Determines the amount of Flutter in the signal. Wow & Flutter Enable
Flutter
must be ON for this control to function.
Crosstalk Enable
Crosstalk is the amount of signal bleed between the left and right channels.
Crosstalk sonics can vary based upon the
rameters, however the amount of crosstalk does not vary with these settings.
Crosstalk Level
This control determines the amount of signal crosstalk. Crosstalk En-
able must be ON for the Crosstalk Level control to function. The default
value of –45 dB is the actual modeled level in the original hardware.
The available range is –50 dB to –10 dB. Crosstalk Level is not affected by au-
tomatic calibration.
Transformer
These ON/OFF buttons enable and disable the transformer cir-
Enable
cuit of the Ampex ATR-102. For an overview of this feature, see
"Modeled Transformer" on page
Tape Delay
UAD Powered Plug-Ins Manual
Wow and Flutter levels change with Tape Speed, but they are not af-
These buttons are global enable/disable controls for the
Crosstalk Level (XTALK) parameter. When Crosstalk is ON, the
amount of Crosstalk can be adjusted using the Crosstalk Level
control.
These parameters control the built-in Tape Delay, which
creates tape echo effects. For an overview of this feature,
see
"Tape Delay" on page
are not available in the original hardware.
Note:
to Input or Thru, nor when the
are active.
Tape Speed
149.
Tape Delay is not available when
- 163 -
and
Head Width
149. The Tape Delay controls
Path Select
Manual Calibration Tools
Chapter 12: Ampex ATR-102
pa-
is set
Advertisement
Table of Contents
