HP Compaq MultiSeat ms6005 Hardware Reference Manual page 72

9.
Before installing an expansion card, remove the expansion slot cover or the existing expansion
card.
NOTE:
attached to the expansion card.
a.
If you are installing an expansion card in a vacant socket, remove the appropriate expansion
slot cover on the back of the chassis. Pull the slot cover straight up then away from the inside
of the chassis.
Figure 3-11
b.
If you are removing a standard PCI card or PCI Express x1 card, hold the card at each end,
and carefully rock it back and forth until the connectors pull free from the socket. Pull the
expansion card straight up from the socket (1) then away from the inside of the chassis to
release it from the chassis frame (2). Be sure not to scrape the card against the other
components.
Figure 3-12
64 Chapter 3 MultiSeat ms6200 Desktop Hardware Upgrades
Before removing an installed expansion card, disconnect any cables that may be
Removing an Expansion Slot Cover
Removing a Standard PCI Expansion Card