Configure The Cyberswitch; Configuring The Options; Configuring The Security - Cabletron Systems Cyber SWITCH 1000 User Manual

C C
ONFIGURE THE
Note: We are assuming that the software has already been installed and is running. Be sure you
are working from the system prompt.
Using the detailed instructions for these steps found in the
complete the following configuration steps.
Start the Run-Time CFGEDIT program
Select physical resources
Select to add a resource
Select Switch type to be NI-1
Select to add a line
Enter the line name
Select slot and port numbers
Select line interface type of "Point-to-Point"
Add Data Links (Data Link explanation follows)
Repeat "Add Data Links" for second Data Link
Repeat "Select to add a line" for each additional line
Data links are handled differently on a NI-1 switch. Some BRI lines have only one phone number
(for the Data Link), but can handle two calls (one for each bearer channel). For NI-1 switches, the
BRI line has two phone numbers (one for each bearer channel), and each phone number has its own
SPID. You must enter the number of digits to verify, so that when the system receives a phone call
it can determine on which bearer to accept the phone call. Refer to the
the SPIDs, directory numbers, and the number of digits to verify.
C O
ONFIGURING THE
The default configuration for the CyberSWITCH is bridging disabled and IP routing enabled. For
reasons we provide below, we want both bridging and IP routing enabled. Under the Option Menu,
select the bridging option and follow the instructions to enable bridging.
This network is a bridged network, but we are going to configure an IP option (the IP host operating
mode) so that we may use an IP application (such as Telnet, TFTP, or SNMP) to manage the
CyberSWITCH. This process was described in the previous chapter
repeated here.
C S
ONFIGURING THE ECURITY
This network has remote devices, and the device information for each of those devices must be
configured. Device security is used, and the remote devices are configured in the on-node
SWITCH
YBER
Choose Auto TEI Negotiation
Enter Service Profile ID (SPID) Value
Enter Directory Number for Data Link
Enter Maximum Number of Digits to Verify
PTIONS
R B N
EMOTE RIDGING ETWORK WITH

Configure the CyberSWITCH

Simple Remote Bridging
System Details worksheet
(page 13) and will not be
Workgroup Remote Access Switch
S
ECURITY
chapter,
for
23