Configuring Security; Save Configuration Files; Verify The Installation - Cabletron Systems Cyber SWITCH 1000 User Manual

C S R
ONFIGURING TATIC OUTES
To configure the static route information for SITE2, refer to the instructions provided for SITE1
(page 71) with the following exceptions:
Static Route for SITE2:
• Enter Y when asked if this static route is a default route.
• Enter SITE1 for the Next Hop name.
C S
ONFIGURING ECURITY
C S O
ONFIGURING YSTEM
Follow the instructions used for configuring the system information for SITE1
following system information exceptions:
• System Name: SITE2
• System Secret: ikcd98s
S C
AVE ONFIGURATION
We have now configured all the required information for SITE2. Return to the Main Menu, save
your configuration files, and exit. Restart the SITE2 to activate the changes.
V I
ERIFY THE NSTALLATION
Steps on how to verify the installation are detailed in the System Verification chapter of the User's
Guide. This section gives an outline of which steps should be executed for Example 1.
On each system:
Verify resources are operational
Verify WAN Lines Available
On SITE1:
Check connectivity to local devices
Check connectivity to SITE2
Check connectivity to remote devices
I
PTIONS AND NFORMATION
F
ILES
Issue dr command
Look for WAN board initialized messages
Look for BRI line messages
Look for LAN initialization messages
Look for Bridge initialization messages
Connect WAN lines
Issue dr command
Look for "Data Link up 1,1" in reports
IP PING 128.1.1.8 (host)
IP PING 128.1.1.3 (server)
IP PING 128.1.1.7 (router)
CALL DEVICE SITE2
IP PING 128.3.3.1 (SITE2)
IP PING 128.3.3.4 (host)
IP R N
OUTING ETWORK WITH

Verify the Installation

(page
Workgroup Remote Access Switch
PPP D
EVICES
74) with the
75