Service Menu - Canon LBP-2000 Service Manual

CHAPTER 1
3 . Restoring the default settings
Types of default settings are as follows:
Factory default settings are those set for each menu item at the factory. The printer uses these
settings changed.
Temporary default settings are those set by the application software for the current print job.
Permanent default settings are those set through the operation panel. These selections remain
in effect even when the printer is turned OFF, or send a different request through the application.
4 . Resetting the default values
This resets various settings to their default values.
MENU: Resets most menu items to their default values.
FONTS: Clears memory of all fonts.
FORMS: Clears memory of all forms
STORED JOB: Clears memory of all stored jobs.
JOB LOG: Clears the job log.
ERR LOG: Clears the error log.
JAM LOG: Clears the jam log.
5 . Shut down
This menu is used to shut down the printer. You should always use this menu to shut down the
printer if the optional Hard Disk HD-65 has been installed.
C. Service Menu
The Service Menu is a hidden menu and contains the following sub menus:
1 . ERR/JAM LOG MENU (Print of Error/Jam log Report)
2 . FORMAT MENU (Format of Hard disk drive and Flash ROM)
3 . NVRAM MENU (Display of counter and copying the counter readings)
4 . PASSWORD MENU (Clear of administrator password)
5 . ENGINE MENU (Clear of fuser error 'E000, E001, E003, E808')
The Service Menu is entered at power up by a sequence of two key presses. Each key press is a
combination of 2 keys.
1 . Press the 'Go' and 'Menu' key together and hold until the LCD displays WARMING UP.
2 . Press the 'Menu', 'Value' and 'Enter' keys together and hold until 'SERVICE MENU' is dis-
played, which should take about 1 second.
The service menu will become operational when the LCD changes to SERVICE MENU.
Figure 1-8-3 lists the Service Menu Operation Flow.
1 - 28