Canon LBP-2000 Service Manual page 116

CHAPTER 3
2 . Removing the right door switch
1) Remove the video controller PCB. (See VII-
B-1 'Removing the Video Controller PCB
unit.')
2) Remove the drive assembly. (See III-B-1
'Removing the Drive Assembly.')
3) Remove the screw [1], and remove the
grounding plate [2].
[2]
Figure 3-1-19
4) Disconnect the connector [3], and free the
harness [4] from the harness guide.
[3]
[4]
Figure 3-1-20
3 - 6
[1]
5) Remove the 3 screws [5], and open the
right rail [6] slightly.
Figure 3-1-21
6) Remove the screw [7], and detach the
grounding plate [8].
7) Free the grounding harness [9] from the
harness guide.
[8]
[9]
Figure 3-1-22
[6]
[5]
[7]