Feeding Mechanisms; Cassette Pickup A S S E M B L - Canon LBP-2000 Service Manual

IV. FEEDING MECHANISMS
A. Cassette Pickup Assembly
1 . Replacing the cassette pickup roller
Caution: Be sure to replace the cassette
separation pad at the same time.
1) Slide out the cassette, and move the front
of the Printer to the edge of the table.
2) Push the lever [1] to the left, and detach
the cassette pickup roller [2].
[1]
Figure 3-4-1
3) Holding the side with the larger hole to
the left, fit the new cassette pickup roller
[3].
[3]
Figure 3-4-2
[2]
2 . Replacing the cassette separation pad
Caution: Be sure to replace the cassette
pickup roller at the same time.
1) Slide out the cassette, and remove all
p a p e r.
2) Turn over the cassette.
3) Pick the claw [1], and remove the cas-
sette separation pad [2].
[1]
Figure 3-4-3
4) Mount the new spring [4] to the new cas-
sette separation pad [3].
Figure 3-4-4
Caution: When replacing the cassette sepa-
ration pad, be sure to apply lubri-
cant to the sliding shaft [5] of the
new separation pad, making sure
that the coating is thin and even.
See that that lubricant is kept
away from areas other than the
above.
CHAPTER 3
[2]
[3]
[4]
[5]
3 - 17