Multifeeder Tray Pickup A S S E M B L - Canon LBP-2000 Service Manual

CHAPTER 3
B . Multifeeder Tray Pickup Assembly
1 . Removing the multifeeder tray
1) Slide out the cassette, and detach the
front cover. (See I-A-3 'Removing the
Front Cover.')
2) Lift the claw on each side [1] to detach,
one after the other.
[1]
Figure 3-4-12
3) Pull the multifeeder tray [2] to the front
and down to detach.
[2]
Figure 3-4-13
3 - 20
Caution: After mounting, check to make
sure that the holding plate [4] is
pushed down by the manual feed
pickup roller cam [3].
If the holding plate is up, turn the
manual feed pickup roller [5] us-
ing lint-free paper (so as to avoid
contact with the roller surface)
while pushing down the holding
plate until the holding plate is
lower than the manual feed pickup
roller cam.
[4]
Figure 3-4-14
2 . Removing the manual
roller
1) Remove the multifeeder tray. (See IV-B-
1 'Removing the Multifeeder Tray.')
2) Remove the 2 stepped screws [1]; hold-
ing it as shown, lift the pickup guide plate
[2] to detach to the front.
[1]
[2]
Figure 3-4-15
[4]
[3]
[5]
feed pickup