Canon LBP-2000 Service Manual page 140

Laser beam printer
Hide thumbs Also See for LBP-2000:
Table of Contents

Advertisement

CHAPTER 3
4) Remove the 2 screws [5], open the pres-
sure roller assembly [6] to about 90, re-
move the D-cut shaft on the right, and
slide it to the right to remove.
When opening the pressure roller assem-
bly, apply force as necessary.
Figure 3-7-9
Note:
1 . The static eliminating brush [7]
can become displaced. Take care
not to lose it.
2 . Be sure to place the fixing roller
assembly [8] on a flat surface so
that it will not tilt; otherwise, the
fixing roller can come off the
b u s h i n g .
[7]
[8]
Figure 3-7-10
3 - 30
[5]
[6]
5) Remove the 2 screws [9] of the pressure
roller assembly, and remove the inlet
guide [10].
[10]
[9]
Figure 3-7-11
6) Remove the spring [11], and detach the
bushing [12], pressure releasing lever
[13], and support plate [14].
7) Remove the pressure roller [15].
[11]
[13]
Figure 3-7-12
Note:
When mounting the pressure roller,
check to be sure that the contact
plate [16] is in contact with the inlet
guide [17].
[16]
Figure 3-7-13
[12]
[15]
[14]
[17]

Advertisement

Table of Contents
loading

Table of Contents