Canon LBP-2000 Service Manual page 123

5) Remove the power switch rod [5].
Figure 3-2-20
6) Remove the 6 screws [6]. Refer to the $
marking to the side of the screw holes to
identify the screws to remove. One of the
screws [7] need not be removed.
[6]
Figure 3-2-21
[5]
[7]
7) Remove the 7 screws [8]. Refer to the $
making to the side of the screw holes to
identify the screws to remove. One of the
screws [9] need not be removed.
[8]
[9]
Figure 3-2-22
Caution: 1 . When mounting, you will not be
able to hold the screwdriver up-
right for screws initiated; nev-
ertheless, be sure the screws are
fitted straight.
2 . Any screws with a washer must
be tightened together with the
respective grounding wire.
8) Holding the rails [10] on both left and
right, detach the printer top unit [11].
[10]
Figure 3-2-23
Caution: Be sure to place the printer top
unit on a flat surface.
CHAPTER 3
[11]
3 - 13