CHAPTER 1
3 . Unpacking and installing the hard disk
Note:
Before handling the hard disk, be sure to touch a metal area of the Printer to avoid dam-
aging the PCBs by static charges.
1) Turn off the Printer, and disconnect the power cord and the interface cable.
2) Take out the hard disk from its packaging box.
3) Remove the vinyl bag used to cover the hard disk.
4) Remove the screw [1], and detach the expansion board slot cover [2].
5) Remove the screw [3], and detach the expansion board slot 1 cover [4].
1 - 12
[2]
[1]
Figure 1-5-2
[3]
[4]
Figure 1-5-3