Canon LBP-2000 Service Manual page 121

1) Push down the ROM slot lever [1].
Figure 3-2-12
2) Holding it so that the cut-off [2] is as
shown, insert the ROM DIMM [3] along
the guide groove.
[3]
[2]
Figure 3-2-13
3) Check to make sure that the protrusion
[4] of the lever is hooked on the groove.
Figure 3-2-14
[1]
[4]
6 . Removing the hard disk (option)
1) Remove the extension board slot cover
and the slot cover.
2) Remove the 2 screws [1], and detach the
hard disk [2].
[2]
Figure 3-2-15
7 . Removing the print sever (Option)
1) Remove the extension slot cover, slot
cover, and rear cover. (See I-A-6 'Remov-
ing the Rear Cover.')
2) Remove the screw [1].
3) Remove the 2 screws [2], and detach the
print sever [3].
[3]
[1]
Figure 3-2-16
CHAPTER 3
[1]
[2]
3 - 11