Setting The Network Board - Canon LASER SHOT LBP-3600 User Manual

10
Make sure that the LNK indicator (green) on the network
board is on.
If the network board is connected with 10BASE-T, the board is working properly
when the LNK indicator is on.
If the network board is connected with 100BASE-TX, the board is working
properly when the LNK indicator and 100 indicator are on.
If the network board is not working properly, turn the power of the printer OFF, and
then check the LAN cable connection, hub performance, and network board
installation.

Setting the Network Board

The default value of the network board is set at "Auto detect". Usually, you do not
need to change the setting, since the transmission speed and transfer mode of
10BASE-T/100BASE-TX are detected automatically. If the printer cannot
communicate with other machines on the network, set the DIP switches on the
network board. Before setting the DIP switches, turn the power of the printer OFF
and remove the network board. A Phillips screwdriver is required for removing the
network board. Have one that matches the size of the screws available. Set the DIP
switches according to the transmission speed of the connected network as follows.
ERR indicator
LNK indicator
100 indicator
Network Board
6
6-45