Removing The Network Board - Canon LASER SHOT LBP-3600 User Manual

13
Install the network board.
NOTE
If the optional duplex unit was previously installed, reinstall it on the printer. For
details on the procedure for installing the duplex unit, see "Installing the Duplex
Unit," on p. 6-32.
14
Connect all interface cables and the power cord to the printer.
15
Plug the power plug into the AC power outlet.

Removing the Network Board

Remove the network board using the following procedure. Have ready the
protective plate and screw for the expansion slot removed when the network board
was installed.
CAUTION
•
Be sure that the power of the printer is turned OFF and all interface cables and
power cord are disconnected from the printer before removing the network
board. Replacing with the power ON or the cables and power cord connected
may result in an electrical shock.
•
Be careful when handling the network board. Touching the edges or a sharp
portion of the network board may result in personal injuries.
1
Press "
unplug the power plug from the AC power outlet.
2
Remove all interface cables and the power cord.
NOTE
If the optional duplex unit is installed, remove it from the printer. For details on
removing the duplex unit, see "Removing the Duplex Unit," on p. 6-34.
3
Remove the 2 screws and remove the network board.
Store the network board in the protective bag that it came in.
" of the power switch to turn the printer OFF, then
Network Board 6-51
6