Canon LASER SHOT LBP-3600 User Manual page 378

1
Press " " of the power switch to turn the printer OFF, then
unplug the power plug from the AC power outlet.
2
Remove all interface cables and the power cord.
NOTE
If the optional duplex unit is installed, remove it from the printer. For details on
removing the duplex unit, see "Removing the Duplex Unit," on p. 6-34.
3
Remove the 2 screws and remove the network board.
IMPORTANT
Do not touch the network board parts, printed wire, or connectors with your hands.
4
Set the DIP switches.
Set the DIP switches with the tip of a ball-point pen etc. For details on the setting
procedure, see the table on p. 6-46.
5
Insert the network board into the expansion slot.
Hold the metal panel portions of the network board and insert the board while
aligning it with the guide rail inside the expansion slot.
IMPORTANT
•
Do not touch the network board parts, printed wire, or connectors with your hands.
•
Insert the printer connector of the network board securely into the connector inside
the expansion slot.
1 0 0
L N K
E R R
C 1
N B -
DIP switches
ON
1 2 3 4
OFF
OFF
Network Board
6
6-47