Setting The Network Board - Canon LBP3310 User Manual

IMPORTANT
The firmware versions of the network board compatible with this printer are as follows.
If the firmware version is not 1.30 or later, the printer may not operate properly. Make
sure that the version is 1.30 or later after installing the network board and the printer
driver.
If the version is not 1.30 or later, update the firmware of the network board using the
update file in the "NB-C2_Firmware" folder in the CD-ROM supplied with the printer.
For details on the procedures for checking and updating the firmware version, see the
README file in the "NB-C2_Firmware" folder.
Also, you can download the firmware update file from the Canon website.

Setting the Network Board

The default value of the network board is set at "Auto detect". Usually, you do not
need to change the setting, since the transmission speed and transfer mode of
10BASE-T/100BASE-TX are detected automatically.
If the printer cannot communicate with other devices on the network, you can
specify the transmission speed and transfer mode by setting the DIP switches using
the following procedure. Set the DIP switches according to the transmission speed
of the connected network as follows.
IMPORTANT
When setting the DIP switches, be careful not to damage the main board with a small tool
such as the tip of a ball-point pen. Do not use a sharp object such as a mechanical
pencil.
9
NOTE
A Phillips screwdriver is required for removing or installing the network board. Have a
screwdriver ready in advance that matches the size of the screws.
9-24 Network Board
Printer
LBP3310
E R R
Firmware Version of the Network Board
Ver. 1.30 or later
* Shown above is the Auto
detect setting (default
1 0 0
L N K
setting)
DIP switches
ON
1 2 3 4
OFF
OFF