Canon LASER SHOT LBP-3600 User Manual page 325

5
5-40 Moving the Printer
• How To Set the Top Rear Cover
If the top rear cover comes off or is not set properly, take the cover out
once using the following procedure, and then set it again, properly.
1. While pressing the top rear cover from both sides a and pressing the
tabs on the top rear cover b, remove the top rear cover c.
a
c
b
b
2. Set the top rear cover.
Fit up the upper left portion of the top
rear cover a, then insert the projection
on the upper right into the hole b.
a
b
The top rear cover is set, snapping. Make sure that the tabs are inserted completely into the
holes.
IMPORTANT
Be sure that the film of the top rear cover does not get
creased when installing the top rear cover.
a
While pressing the tabs on the back of
the top rear cover c, insert the tabs into
the holes d to set the top rear cover.
c
Film
c
d
d