Lucent Technologies PARTNER Advanced Communications System Release 1.0 Installation Manual page 35

4
A) Connect the line and extension cords one at a
time, making sure to place the correct cords
into their corresponding jacks on the new
module. (See "Connecting Lines and
Extensions" earlier in this guide.)
B) Reconnect the power cord.
C) Move the carrier's On/Off switch to the "On"
position ("l").
5
Check that all green lights on the fronts of the modules
are lit:
A) If a single light is out , power down the control
unit, reseat the module, then power up the
control unit.
If multiple lights are out , power down the
control unit, reseat the leftmost module that
has a light out, then power up the control unit.
B) If the lights are still out , call for support as
instructed on the inside front cover of this
guide.
6
A) Make sure all modules are seated properly. The
cover will not fit if the modules are not seated
properly.
B) To replace the cover, grasp it by its upper
edges and hold it squarely over the control
unit.
C) Place the cover over the modules and make
sure it fits firmly in place.
D) Tighten the screw on the lower front of the
cover.
Lights
PFT PFT
L L
I I
N N
E E
S S
PFT
1 L
I
N
PFT
2 E 3 L
S I
N
PFT
4 E L
PAGE
S I
N
E PFT
L
S 5
206 I
MODULE N
E
6
S
206
MODULE
PFT
PROCESSOR
10 MODULE
E PFT 206 206
11 16
MODULE MODULE
X
T
12
E 17 E
N X
T
13 S
18 E VOL
I
O N
14 N 19 S
I
S
O MUSIC
ON
15 20
N HOLD
S
21
Screw
Equipment Upgrades 31