Lucent Technologies PARTNER Advanced Communications System Release 1.0 Installation Manual page 24

Wall Mounting
Wall mounting instructions apply only to PARTNER- model phones. For all other system phones,
follow the instructions provided with the phone.
1
A) Reverse the plastic hook that sits in the earpiece
part of the handset cradle.
B) Turn the phone upside down and remove the tray
that holds the User Instruction cards : press
the tabs on both sides of the tray near the pull
out tab while you slide the tray straight out.
2
Holding the stand with the wide edge down, mount
the stand on the wall plate using the keyholes on
the base of the stand. For proper mounting, the
wall plate must be a Lucent Technologies 630B
connecting block.
3
A) Plug one end of the telephone cord into the jack in
the center of the wall plate.
B) Plug the other end of the telephone cord into the
LINE jack on the bottom of the telephone.
C) Wrap any excess cord around the cord wrap
posts on the bottom inside of the stand.
4
A) To mount the phone on the stand, insert the tabs on
the top of the stand into the middle set of
notches on the top edge of the phone.
B) Make sure the telepone cord is neatly wrapped
inside the phone, then rotate the phone down
until the bottom edge snaps into position.
20 Installation Procedures
To
LINE
Jack