Lucent Technologies PARTNER Advanced Communications System Release 1.0 Installation Manual page 14

5
Attach the 2-Slot carrier to the top right side of
the two modules. Align the carrier carefully and
then push firmly until the connectors on the
modules snap into the carrier.
6
Fasten the carrier to the modules using the two #4
screws included with the carrier.
7
Insert the 3-1/2" #8 screw into the bottom of the
modules. Tighten the screw until the mounting
tracks of the PARTNER ACS processor module are
flush against the wall and there is a 3/8" (1 cm.)
gap between the wall and the rest of the PARTNER
ACS module. Do not overtighten—the modules will
warp and fail to operate.
8
Label the lines and extension jacks as shown. (If your
second module is a 400 module, you will have
lines 1–7 but only extensions 10–17.)
9
Skip to "Inserting Batteries in the PARTNER ACS
Processor Module."
10 Installation Procedures
PARTNER
2 0 6
E D U L M O
ACS
L
I
Processor
N
E
S
Module
Lines
PFT
E
X
T
E
N
S
I
O
Extensions
N
S
206
Module
Lines
Extensions